sunsetsprings:


DIY Arizona Iced Tea Earrings

First, draw a general teardrop shape on the sheet of aluminum. 

You can cut through with just regular scissors. 

Take the earring and lay it against a cardboard surface. Use a sewing needle to poke a hole near the top. Since it’s on cardboard, you won’t end up puncturing your table. Also, because it’s laying down, the aluminum won’t bend at the impact verses holding it in your hand.

Take wire (mine was just electrical wire) and cut it with scissors about 4 inches long. 

Thread the earring, leaving room in front.

Twist the space into a small loop. 

Twist 2 to 3 times until the loop is facing flat, the same direction as the earring.

Cross the wire to the back and twist the two ends tightly together.

Clip the ends shorter with scissors. Open up the loop of the already made French loops available at craft stores and attach the wire loop. Squeeze the loop back together. Here is the finished product. Enjoy your homemade, recycled earrings. 
Just a note: You might want to trim the very top part that is pointy to avoid cutting your ear lobe. 
If you have any questions, please feel free to ask me!

sunsetsprings:

DIY Arizona Iced Tea Earrings

image

First, draw a general teardrop shape on the sheet of aluminum. 

image

You can cut through with just regular scissors. 

image

Take the earring and lay it against a cardboard surface. Use a sewing needle to poke a hole near the top. Since it’s on cardboard, you won’t end up puncturing your table. Also, because it’s laying down, the aluminum won’t bend at the impact verses holding it in your hand.

image

Take wire (mine was just electrical wire) and cut it with scissors about 4 inches long. 

image

Thread the earring, leaving room in front.

image

Twist the space into a small loop. 

image

Twist 2 to 3 times until the loop is facing flat, the same direction as the earring.

image

Cross the wire to the back and twist the two ends tightly together.

image

Clip the ends shorter with scissors. Open up the loop of the already made French loops available at craft stores and attach the wire loop. Squeeze the loop back together. Here is the finished product. Enjoy your homemade, recycled earrings. 

Just a note: You might want to trim the very top part that is pointy to avoid cutting your ear lobe. 

If you have any questions, please feel free to ask me!

Notes

  1. elisieloo236 reblogged this from drinkarizona
  2. amazingdanisnotfire reblogged this from drinkarizona
  3. kissing-and-loving-angel reblogged this from drinkarizona
  4. foofighter42 reblogged this from drinkarizona
  5. somanythoughtzz reblogged this from truebluemeandyou
  6. urban-herb reblogged this from moons-and-mirrors
  7. rass-lynch reblogged this from moons-and-mirrors
  8. moons-and-mirrors reblogged this from aces-of-diamonds
  9. rachiemonster reblogged this from aces-of-diamonds
  10. aces-of-diamonds reblogged this from inbloomnewyork
  11. one-hundred-years-of-ineptitude reblogged this from truebluemeandyou
  12. b3autiful-mem0ries reblogged this from truebluemeandyou
  13. 99bottlesofmilk reblogged this from truebluemeandyou
  14. disorder-hell reblogged this from gay4life2k12
  15. aper-dash-ture reblogged this from truebluemeandyou

← Previous Post Next Post →

AriZona Beverage Co.


Ask me anything Submit

Following

Connect